Activity pages not moving to remote

Evening all, super new to the UCR2. Was able to get my Nvidia Shield integrated and loaded IRs for my Onkyo Receiver and Epson projector.

I built a very basic activity called “Watch A Movie”. Setup the Off and On scripts and mapped many of the buttons. I have run into one issue. I created a page for the display for a couple of additional text buttons (aspect ratio controls, sound formats, etc). They setup and test OK, but this page never transfers to the display of the remote.

Am I missing something? Everything else I’ve done didn’t need to be enabled, synched or “sent” and just gets there.

Go back once, enter the activity again and swipe to check. I’ve seen sometimes that adding pages do not take effect if you are in activity on remote. (You are on latest firmware, right?)

1 Like