A 3D Printable Case for the Remote 3

General
1

I have created a case for the Remote 3 and posted on MakerWorld: https://makerworld.com/en/models/1519219-unfolded-circle-remote-3-case#profileId-1591904

2 Likes
2

Neat, is this a TPU case that goes over the remote for added protection not requiring disassembling the remote? While I haven’t received mine yet it’s awfully thin so.e outer protection would be nice using some TPU 85a would also make it feel nice in your hand. Not that it doesn’t without the case.

3

Yes, it fits over the remote without the need to disassemble the remote. It is in two parts, the bottom end cap is a friction fit to allow removal for charging in the dock.